Table of Contents
Advertisement
8.73 ~JC SET MEDIA SENSOR CALIBRATION
Format: ~JC
Calibration is performed based on the current sensor values.
*1
As the set label length is temporarily updated, the amount of paper feed with the [FEED] key is
changed. (The value is restored to the one of the default setting file by turning off/on the unit.)
*2
If the operation does not end normally until the paper is fed for the set amount or 990 mm, "PAPER
JAM" is generated.
*3
When "SENSOR" in the Z-MODE parameter is set to 'NONE,' no operation is performed with this
command.
*4
The label length, sensor selection, and ribbon selection obtained through execution of calibration in
the Z-MODE cannot be modified.
*5
When the "Auto calibration setting" for Oki Data is set to 'ON,' Z-MODE calibration is not performed.
To enable Z-MODE calibration, ensure the "Auto calibration setting" for Oki Data is set to 'OFF.'
*6
Priority is as shown below.
Oki Data system setting > Z-MODE system setting > Issuance command or Feed command
*7: The recommended length is as follows:
10.0 mm to 177.8 mm (7 inches)
- 112 -
Advertisement
Table of Contents
