Oversize Cast Faceplate Installation - Regency Hampton HI2450 Owners & Installation Manual

Oversize Cast Faceplate Installation

Enamel & Cast components are very fragile. Use extreme care when handling.
FACEPLATE CONTENTS LIST
Qty Description
Left Side Faceplate
Right Side Faceplate
Top Faceplate
Side Mounting Brackets
1/4" - 20 x Hex Nuts
1/4" - 20 x 1" Hex Head Bolts
1/4" Flat Washers
47" Insulations
mm g sket
1) Secure the Side Mounting Brackets (packaged with Faceplate) to the
left and right side of the fi rebox using 2 bolts per mounting bracket
as shown in the diagram below. Bolts are pre-installed on unit.
Leave bolts loose until fi nal adjustment is made.
Side Mounting
Bracket
Backside of Unit Shown.
918-967
OVERSIZE CAST FACEPLATE INSTALLATION
Stop! Read Carefully.
2) Secure the Left and Right Side Faceplate to the fi rebox by aligning
the Mounting Holes with the Side Mounting Brackets taking care to
align vertically while each side rests on the hearth. Secure using 2
bolts per bracket.
Side Mounting
Right Side Face-
plate
Backside of Unit & Faceplate Shown.
3) Place 1/4" x 1" Hex head bolt with 2 washers in Mantel Top Spacer
locations shown below.
4) Place Mantel Top onto the top of the fi rebox.
Mantel Top Spacer
With the Mantel Top in place check to make sure there is no gap
between the Mantel Top Spacer and the underside cast of the Mantel
Top. If there is a gap present you will need to lower that side cast by
loosening 2 bolts, see side cast adjustment section for bolt location
(check to see if level).
1
installation
Mounting
Bracket
Mantel Top
HI300
|
15
Hole
Left Side Face-
plate
Right Side
Cast
| 15
Regency HI2450M
05/02/11