Renault CLIO 2019 Vehicle User Manual page 167

TyrE PrEssUrE loss warning
"check tyre press and init." (contin-
ued)

The warning light
several seconds, then stays on, along
with the message "Check tyre press
and init.".
They indicate that the request to reset
the reference value of the tyre pres-
sures must be restarted.
"TPw not available"

The warning light
several seconds, then stays on, along
with the message "TPW not available".
They indicate that the vehicle is
equipped with an emergency spare
wheel which is smaller than the other
four and that it is fitted to the vehicle.
"check TPw"

The warning light
several seconds, then stays on, along
with the message "Check TPW".
This message is accompanied by the
©
warning light .
They indicate a system fault. Please
consult an authorised dealer.
(4/4)
readjustment of tyre pressures
The tyre pressures must be adjusted
when cold (please refer to the label lo-
flashes for
cated on the edge of the driver's door).
If tyre pressures cannot be checked
when the tyres are cold, the recom-
mended pressures should be increased
by 0.2 to 0.3 bar (3 PSI).
never deflate a hot tyre.
After each reinflation or readjustment of
the tyre pressure, launch the reinitiali-
sation of the tyre pressure reference
flashes for
value.
replacing wheels/tyres
Only use equipment approved by the
network, otherwise the system risks
late activation or incorrect operation.
➥ 5.11.
flashes for
After each change of wheel/tyre, read-
just the tyre pressure and launch the
reset of the tyre pressure reference
value.
Emergency spare wheel
If fitted on the vehicle, readjust the tyre
pressure and launch the reinitialisation
of the tyre pressure reference value.
Tyre repair product and inflation kit
Only use equipment approved by the
network, otherwise the system risks
late activation or incorrect operation.
➥ 5.4.
After using the tyre inflation kit, readjust
the tyre pressure and launch the reini-
tialisation of the tyre pressure reference
value.
2.35