Adjusting The Entrance Detector Switch - Kodak X-Omat 460 RA Processor Service Manual

Adjusting the Entrance Detector Switch

The following procedure does not apply if you have a MULTILOADER or an AUTOMATIC FILM FEEDER. Call
Service Support if you need another version of this adjustment procedure.
For this procedure the processor must be energized, and the TOP COVER and DRIVE SIDE
ACCESS PANEL must be removed from the processor. See pages 1-3 through 1-6.
[1] Make sure that the processor is energized. The MAIN CIRCUIT BREAKER, CB1, should be in the ''I''
position.
[2] Set the processor to the Standard Cycle. See the Operator Manual.
[3] Make a FILM TOOL. Use the following specifications:
2.54 cm (1.0 in.)
5.08 cm (2.0 in.)
5.08 cm (2.0 in.)
30.48 cm (12 in.)
636739
Do this adjustment when the REPLENISHER PUMPS malfunction.
Remove this strip and discard.
Film area that must be under the LED's.
Green (Unexposed)
Figure 6-2 Making a Film Tool
NOTE
IMPORTANT
Remove this strip and save.
Radiographic Film
43.18 cm (17 in.)
10.16 cm (4.0 in.)
25.40 cm (10 in.)
H108_0168DC
6-3