Adjusting The Film Feed Signal - Kodak X-Omat 460 RA Processor Service Manual

Adjusting the Film Feed Signal

The adjustment for the loudness of the FILM FEED SIGNAL is controlled by the R44
POTENTIOMETER on the 5600 CIRCUIT BOARD. The location for the adjustment is above the
FEED TRAY.
[1] To adjust the loudness of the FILM FEED SIGNAL, rotate the R44 POTENTIOMETER using a
POTENTIOMETER ALIGNMENT TOOL. Rotate the R44 POTENTIOMETER clockwise to make the
signal louder and counterclockwise to make the signal quieter.
6-2
NOTE
Figure 6-1 Adjusting Loudness
R44
POTENTIOMETER
H108_0158DCA
H108_0158DA
636739