Motor Specifications; Lubrication Guide - Standard Compressors - Sullair TS32 Series User Manual

Industrial rotary screw air compressor, 200-350hp/149-261kw air-cooled & water-cooled standard and 24kt
Hide thumbs Also See for TS32 Series:
Table of Contents

Advertisement

TS32 USER MANUAL
3.3

MOTOR SPECIFICATIONS

MOTOR: (60 Hz Compressors)
Size:
Type:
Options:
Speed:
Starter:
3.4
LUBRICATION GUIDE—
STANDARD COMPRESSORS
WARNING
Before changing or recharging system fluid
always relieve all pressure from the sump tank
and all compressor lines.
NOTE
Sullair standard compressors are filled with
Sullube fluid as factory fill.
Mixing of other lubricants within the com-
pressor unit will void all warranties.
Refer to Figure 3-1. Sullube fluid should be changed
every 8000 hours or once a year, whichever comes
first. The fluid should be changed more frequently
under severe operating conditions, such as high
ambient temperatures coupled with high humidity, or
when high particulate level, corrosive gases or strong
oxidizing gases are present in the air.
28
STANDARD MODELS:
200-350HP/150-261Kw- Consult factory for specific voltages
Open Dripproof enclosure, 3-phase, 50 or 60 hz, 104°F / 40°C Maximum
Ambient Temperature
Various voltages, TEFC enclosure, CE approved (50 hz), Premium
efficiency
1780 RPM (60 hz), 1475 RPM (50 hz)
Full-Voltage, Wye-Delta or Solid State
"The Plastic Pipe Institute recommends against
the use of thermoplastic pipe to transport com-
pressed air or other compressed gases in
exposed above ground locations, e.g. in
exposed plant piping." (I) PVC piping should
not be used with Sullube. It may affect the
bond at cemented joints. Certain other plastic
materials may also be affected.
(I) Plastic Pipe Institute, Recommendation B,
Adopted January 19, 1972.
Maintenance of all other components is still
recommended as indicated in the Operator's Manual.
Sullair encourages the user to participate in a fluid
analysis program with the fluid suppliers. This could
result in a fluid change interval differing from that
stated in the manual. Contact your Sullair dealer for
details.
A fluid sample at every 1000 hours is recommended.
For a free Sullube analysis, send fluid to:
Dow Chemical
Lubricant Technology Center
Building B-1605
Freeport, TX 77541
To facilitate this, a sample bottle is included with the
compressor.
SECTION 3
CAUTION

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ts32 wcTs32 acTs32-200Ts32-250Ts32-300Ts32-350

Table of Contents