Removal - IBM 5280 Maintenance Information Manual

AC Drive Motor with Internal Fan
Removal
1.
2.
3.
Power off.
DANGER
Capacitor discharge voltage might be present at the
socket when the AC drive motor power cable is
disconnected.
Disconnect the AC drive motor power cable
fJ.
Remove the AC drive motor belt
II.
High voltage might be present at the capacitor terminals.
I
DANGER
4. Remove the two insulator caps
Dfrom
the capacitor
terminals.
5. Discharge the capacitor by jumpering its terminals
with a large bladed screwdriver.
6.
7.
Remove the AC drive motor leads
II
from the
capacitor terminals.
Remove the two insulator caps from the AC drive
motor leads.
30 AC Drive
351
8.
9.
Loosen the setscrew
D;
then remove the AC drive
motor pulley
II.
Remove the four AC drive motor mounting screws
fJ ;
then remove the AC drive motor.
Replacement
1.
2.
3.
4.
Reinstall the AC drive motor
0
with the four
mounting screws
IJ
(leave the four screws loose).
Reinstall the AC drive motor pulley
II.
Ensure
that the setscrew
D
is centered on the flat surface
of the motor shaft (leave the setscrew loose).
Move the AC drive motor pulley
II
toward the AC
drive motor until the AC drive motor pulley is in the
casting
II;
then tighten the four AC drive motor
mounting screws
fJ.
Move the AC drive motor pulley out of the casting
and tighten the setscrew
D
(the allen wrench
should be flush with the casting when you tighten
the setscrew).
5. Reconnect the AC drive motor cable
fl.
6. Reinstall the AC drive motor leads
0;
note the
cable numbers to determine which lead goes on which
terminal.
7. Reinstall the two insulator caps
Don
the
capacitor term inals.
8. Reinstall the AC drive motor belt
iii .