Diskette Drive Assembly; Removal; Replacement - IBM 5114 Maintenance Information Manual

111
DISKETTE DRIVE ASSEMBLY
Removal
1.
2.
Turn off the POWER switch on the 5110 and
unplug the 5114 line cord.
Remove the front cover (110).
3. Remove the signal cable from the signal cable
clamp
II.
4.
5.
6.
7.
8.
9.
2-14
Remove the power cable from the power cable
clamp
II.
Loosen the diskette drive fastener knob
II
or
B.
Carefully slide the diskette drive,
II
or • toward
the front of the 5114.
Lift up the diskette drive and remove it from the
5114.
Unplug the signal cable from the diskette drive
control card socket
II.
Unplug the power cable from the diskette drive
motor connector
II.
Replacement
1.
2.
3.
4.
5.
Replace the diskette drive by reversing steps 3
through 9 of the removal procedure.
CAUTION
The cable routing must be the same as when the
diskette drive was removed because of
electrostatic noise.
Check the performance of the diskette drive using
MAP 880.
Set the front cover in place to check the alignment
of the diskette drives to the openings in the front
cover. If the diskette drives line up with the
openings, go to step 6. If the diskette drives do
not line up with the openings, go to step 4.
Loosen the diskette drive fastener knob
II
or
II
and slide the diskette drive out to allow access to
the diskette drive locator slot screws.
Loosen the diskette drive locator slot screws and
position the diskette drive to fit correctly in the
cover opening. Tighten the screws.
6. Replace the front cover (110).
/----,,-
~,
. . " _.J/