Siemens SINUMERIK 840D sl Function Manual page 1715

REPOS offset, 1627
REPOS offset valid, 1627, 1628
Repos Path Mode Ackn0-2, 1624, 1625
REPOSDELAY, 1627, 1628
REPOSMODEEDGEACKN, 1624
Reset, 1613
Re-synchronizing spindle when positioning 1 and
2, 1639
Resynchronizing spindles 1 and 2, 1638
Revolutional feed rate active, 1670
Rigid tapping active, 1647
Run-up completed, 1585
S auxiliary function for spindle, 1600
S function for spindle, 1649
Screen bright, 1556
Screen is dark, 1561
Second software limit switch plus or minus, 1590,
1591
Selected JOG mode, 1606
Selected machine function REF, 1606, 1607
Selected mode AUTOMATIC, 1605
Selected mode MDA, 1605
Selected mode TEACH IN, 1606
Selection, 1564
Sensor for fixed stop, 1594
Sensor S1 available (clamped state), 1649
Sensor S4 available (piston position), 1649
Sensor S4, piston end position, 1651
Sensor S5 available (angular position of the motor
shaft), 1650
Sensor S5, angular position of the motor
shaft, 1651
Sensors available, 1649
Setpoint direction of rotation, counter.clockwise/
setpoint direction of rotation, clockwise, 1642
Setpoint gear stage A to C, 1643
Setpoint speed increased, 1645, 1646
Setpoint speed limited, 1644, 1645
Simulation active, 1562
Single block type A, 1605
Single block type B, 1604
Speed controller active, 1580
Speed controller integrator disable, 1577
Speed controller integrator disabled, 1583
Speed limit exceeded, 1644
Spindle in position, 1648
Spindle in setpoint range, 1646
Spindle override, 1668, 1669
Spindle reset/Delete distancetogo, 1636
Spindle/no axis, 1642
State value is generated, speed limitation p5043
is active, 1650
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Status of the clamping system, 1650
Still ASUB is active, 1626
Stop at the end of block with SBL is
suppressed, 1621
Switch over MCS/WCS, 1562
Synchronized Actions (S5, H2)|Signals for
dynamic M functions: M0 - M99, 1599, 1600
T function 1, 1598
Transformation active, 1617
Unload part program, 1558, 1559
Unloading, 1563
Velocity/spindle speed limitation, 1590
Workpiece setpoint reached, 1622
Intermediate gear, 343, 1249
Interpolator end, 181
Interpolatory axis grouping, 46
Interrupt
-lock, 569
routine, 559
signal, 559
Interrupt routine
End, 561
Inverse-time feedrate (G93), 1310
IR, 1326
J
Jerk
-increase, velocity-dependent jerk, 268
Jerk limitation, 197
Jogging
during interruption of a JOG ASUB, 565
in the mode type AUTOMATIC, 464
JR, 1326
K
Key disable, 39, 884
Key switch, 63
Kinematic transformation, 696
Kinematic type, 1446
KONT, 1404
KONTC, 1404
KONTT, 1404
KR, 1326
L
LENTOAX, 1531
LFOF, 1322
LFON, 1322
Index
1715