Signals To Axis/Spindle (Db31; Signals From Axis/Spindle (Db31 - Siemens SINUMERIK 840D sl Function Manual

DB21, ...
DBX384.0 Control program branching
Edge evaluation: No
Signal state 1 GOTOS in the part program initiates a return to the program start. The program is then processed
again.
Signal state 0 GOTOS initiates no return. Program execution is continued with the next part program block after
GOTOS.
Corresponding to ... MD27860 $MC_PROCESSTIMER_MODE (activation of the program runtime measurement)
MD27880 $MC_PART_COUNTER (activation of workpiece counters)
19.6.5

Signals to axis/spindle (DB31, ...)

DB31, ...
DBX10.0 REPOSDELAY
Edge evaluation: no
Signal state 1 The REPOS offset of the axis is first applied with its next programming.
Signal state 0 There is no REPOS offset.
Special cases, The signal is not relevant for path axes.
errors, ......
Corresponding to ... DB21, ... DBX31.0 - DBX31.2 (REPOS mode)
DB31, ... DBX70.2 (REPOSDELAY acknowledge)
DB31, ... DBX72.0 (REPOSDELAY)
19.6.6

Signals from axis/spindle (DB31, ...)

DB31, ...
DBX70.0 REPOS offset
Edge evaluation: no
Signal state 1 or A REPOS offset must be applied for the appropriate axis.
edge change
0 → 1
Signal state 0 or No REPOS offset need be applied for the appropriate axis.
edge change
1 → 0
Corresponds to .... DB31, ... DBX70.1 (REPOS offset valid)
DB31, ...
DBX70.1 REPOS offset valid
Edge evaluation: no
Signal state 1 or The range of validity of the REPOS offset is indicated with the value 1.
edge change The REPOS offset was calculated to be valid.
0 → 1
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
19.6 Mode group, channel, program operation, reset response (K1)
Signal(s) updated:
Signal(s) updated: Cyclically
Signal(s) updated: cyclic
Signal(s) updated: cyclic
Z1: NC/PLC interface signals
1627