Siemens SINUMERIK 840D sl Function Manual page 1527

0:
-1:
-2:
-3:
-4:
-5:
-6:
-7:
-8:
-9:
-10: Illegal numerical value for the _CORMODE parameter.
-11: The contents of the _COMP and _CORRCOMP parameters are contradictory.
-12: The contents of the _COMP and _CORRMODE parameters are contradictory.
-13: The content of the _GEOAX parameter does not designate a geometry axis.
-14: Write attempt to a non-existent setup offset.
_CORVAL[3]
Designates the offset vector.
In this case, in the workpiece coordinate system (WCS) defined using _STAT the following
are assigned:
● _CORVAL[0] of the abscissa
● _CORVAL[1] of the ordinate
● _CORVAL[2] of the applicate
If only one tool component is to be corrected (i.e. no vectorial correction, see parameter
_CORMODE), the correction value is always in _CORVAL[0], independent of the axis on
which it acts. The contents of the other two components are then not evaluated.
If _CORVAL or a component of _CORVAL refers to the transverse axis, then the data is
evaluated as radius dimension. This means that a tool is e.g. "longer" by the specified
dimension; this correspondingly results in a change to the workpiece diameter that is twice
as large.
The dimensions refer to the basic system (inch or metric) of the control system.
_COMP
String that comprises either one or two characters. The first or only character for the 1st
component (Val
cessed according to the subsequent parameters _CORCOMP and _CORMODE.
Basic Functions
Function Manual, 01/2015, 6FC5397-0BP40-5BA2
Function OK
No memory reserved for tool environments:
MD18116 $MN_MM_NUM_TOOL_ENV = 0 (number of tool environments in TO
area).
i.e. the "tool environments" functionality is not available.
A tool environment with the name specified in _STAT does not exist.
Invalid string in parameter _COMP.
Causes of this error can be invalid characters or characters programmed twice.
Invalid T number.
Invalid D number.
Invalid DL number.
Attempt to access a non-existent memory module.
Attempt to access a non-existent option (programmable tool orientation, tool man‐
agement).
Illegal numerical value for the _CORCOMP parameter.
REAL
STRING
) and the second character for the 2nd component (Val
1
W1: Tool offset
18.12 Working with tool environments
array
), which are pro‐
2
1527