Controlling Other Tvs With The Remote Commander - Sony SLV-SE50EG Operating Instructions Manual

To
Adjust the volume of the TV
Switch to TV (Teletext off)
Switch to Teletext
Select the sound
Use FASTEXT
Call up on-screen display
Change the Teletext page
Switch to/from wide mode of a Sony wide TV (For
other manufacture's wide TV, see "Controlling other
TVs with the remote commander" below.)
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery with an old one together.
• Do not use different types of batteries together.
• Some buttons may not work with certain Sony TVs.

Controlling other TVs with the remote commander

The remote commander is preprogrammed to control non-Sony TVs. If your
TV is listed in the table on the next page, set the appropriate manufacturer's
code number.
1
Set TV / VIDEO at the top of the remote commander to TV .
2
Hold down I/u, and enter your TV's code number(s) using the
programme number buttons. Then release I/u.
Now you can use the following TV control buttons to control your TV:
I/u, ... TV/VIDEO, programme number buttons, ? (ten's digit),
PROG +/–, Á +/–, ; (TV), V (Teletext), FASTEXT buttons, WIDE*,
MENU*, >*/.*/?*//*, and OK*.
* These buttons may not work with all TVs.
Tip
• When you set your TV's code number correctly while the TV is turned on, the TV
turns off automatically.
Press
Á +/–
; (TV)
V (Teletext)
AUDIO MONITOR
FASTEXT buttons
DISPLAY
√/◊
WIDE
continued
Getting Started
7