Step 2 : Setting Up The Remote Commander - Sony SLV-SE100K Operating Instructions Manual

Step 2 : Setting up the remote commander

Inserting the batteries
Insert two R6 (size AA) batteries
by matching the + and – on the
batteries to the diagram inside the
battery compartment.
Insert the negative (–) end first,
then push in and down until the
positive (+) end clicks into
position.
Using the remote
commander
You can use this remote
commander to operate this VCR
and a Sony TV. Buttons on the
remote commander marked with a
dot (•) can be used to operate your
Sony TV. If the TV does not have
the symbol near the remote
sensor, this remote commander
will not operate the TV.
To operate
the VCR
a Sony TV
Set [TV] / [VIDEO] to
[VIDEO] and point at the remote sensor at the VCR
[TV] and point at the remote sensor at the TV
Remote sensor
1 2 3
4 5 6
8
0
Setting up the remote commander
[TV] /
[VIDEO]
continued
5