Sony SLV-SE100K Operating Instructions Manual page 57

Tip
• To set tracking to the centre position, press the TRACKING + and – buttons at the same time.
Notes
• You can adjust the tracking for an NTSC-recorded tape but the tracking meter won't be
displayed.
• With the Auto Long Play function* on, the OPC function will work only in SP mode. If the
tape speed automatically switches from SP to LP, the OPC function turns off. If, however, the
entire programme is recorded in LP mode, the OPC function will work.
• There is a delay of about ten seconds before the VCR actually starts recording while the VCR
analyses the tape. To avoid the delay, first set the VCR to recording pause (the OPC indicator
flashes slowly) and press z REC to have the VCR analyse the tape (the OPC indicator
flashes rapidly) and return to recording pause. After the OPC indicator stops flashing, press
X PAUSE to start recording immediately.
If you want to start recording quickly without using the OPC function, first set the VCR to
recording pause (the OPC indicator flashes slowly) and press X PAUSE again to start
recording
* not available on SLV-SE100K/SX100K
Adjusting the picture
57