Table of Contents
Advertisement
1 Audio control section
1 Audio selection function selector buttons
2 DISPLAY FULL/FINE button
3 Audio setting display section
6 PB controls
5 REC controls
1 Audio selection function selector buttons
INPUT (input signal selection mode) button:
Pressing this button puts the unit into input signal
selection mode. In the audio setting display
section, indicators flash to indicate the currently
selected signal for each channel (HDSDI, SDTI,
AES/EBU, or ANA). In this state, you can use the
audio monitor signal selection buttons to select the
signal to input to each channel.
Pressing this button again takes the unit out of
input signal selection mode and puts it into
monitor signal selection mode.
MIXING (mixing setting mode) button: Pressing
this button puts the unit into mixing setting mode.
In the audio setting display section, the MIX
indicator flashes. In this state, you can use the
audio monitor signal selection buttons to specify
which input channel signal will be recorded on
which audio track on the tape.
Pressing this button again takes the unit out of
mixing setting mode and puts it into monitor
signal selection mode.
For information about how to operate in input signal
selection mode, mixing setting mode, and monitor signal
selection mode, see the descriptions of the audio monitor
signal selection buttons 4 on page 2-6.
2 DISPLAY FULL/FINE button
Pressing this button toggles the display mode of the
level meters in the audio setting display section
between FULL and FINE.
4 Audio monitor
signal selection
buttons
3 Audio setting display section
FULL: The display covers the range –60 dB to 0 dB
or –40 dB to +20 dB as selected using setup menu
item 806. In this mode the segment of the display
corresponding to the current audio level and all
lower segments light.
FINE: The display is enlarged, with a step of
0.25 dB. A segment indicating the reference level
lights. In this mode only the segment of the
display corresponding to the current audio level
lights. If the audio level exceeds the maximum
display level, the top segment flashes, and if the
audio level goes below the minimum display
level, the bottom segment flashes.
HDSDI SDTI
DATA indicator
AES/EBU/ANA
DATA
5 6 7 8
MIX 1 2 3 4
MIX indicator
dB
OVER
0
OVER indicator
-10
-20
-30
-40
-60
L
EMPH
EMPH indicator
Input signal indicator: Indicates the currently
selected input signal (HDSDI, SDTI, AES/EBU,
or ANA for analog) for the corresponding audio
input channel.
MIX (mixing) indicator: Flashes when a mixing
setting operation is enabled for the corresponding
audio track. The indicator showing the number of
the selected input channel lights.
Chapter 2 Location and Function of Parts
Input signal indicator
Input channel
indicator
dB
20
2
10
1
Level meter
0
-1
-10
-20
-2
-40
R
Monitor channel L
and R indicators
2-5
Advertisement
Table of Contents
