Kohler 15CCO Service Manual page 118

5. Remove the nuts using a 3/8-inch wrench and
disconnect the ground strap from the controller.
See Figure 8-22.
1
1. Ground Strap
Figure 8-22. Disconnecting the Controller
Ground Strap
6. Remove the controller.
7. Disconnect P8 from J8.
8. Remove the six screws securing the end bracket
panel to the end bracket using a 5/16-inch wrench
or nut driver. Remove the end bracket panel to
expose the exciter. See Figure 8-23.
1. Screw
Figure 8-23. Removing the End Bracket Panel
9. Disconnect P6 from J6 and P7 from J7.
8-8 Disassembly/Reassembly
2
2. Nuts
2
1
2. End Bracket Panel
10. Remove the four screws securing the exciter field
to the end bracket. Carefully remove the exciter
field from the generator. See Figure 8-24.
1. Screw
Figure 8-24. Removing the Exciter Field
11. Remove the three screws and spacers securing
the rotating diode circuit board to the rotor
armature. See Figure 8-25.
2
1. Screw
Figure 8-25. Removing the Diode Circuit Board
12. Remove the five screws securing the leads to the
rotating diode circuit board. Carefully separate the
rotating diode circuit board from the rotor
assembly.
1
2
2. Exciter Field
1
2. Diode Circuit Board
TP-5606 6/02