Table of Contents
Advertisement
SAFETY SYMBOL SUMMARY
This equipment has been supplied with numerous safety and operating decals. These decals provide important
operating instructions and warn of dangers and hazards. Replace any missing or hard-to-read decals and use care
when washing or cleaning the unit. Decal placement and part numbers can be found in the parts manual. Below is
a summary of the intended meanings for the symbols used on the decals.
Safety alert symbol;
used to alert you
to potential hazards.
Hot surface(s) nearby.
Dangerous voltage may
be present.
Ultraviolet radiation
hazard; operate only
with lens intact.
Check diesel fuel fill
level.
Read and understand
the operator's manual
before operating.
Stop engine.
STOP
Anchor/tie down point.
Do not drink the water.
Asphyxiation hazard;
operate in well venti-
lated area.
Burn/scald hazard;
pressurized steam.
Wind hazard; do not set
up in wind speeds
greater than 60 mph
> 60 mph
(95 km/h).
Electrical storm hazard.
Allow to cool.
Wait 15 minutes.
15 MIN
Disconnect battery
before servicing.
Unit electrical ground.
Belt/entanglement
hazard; keep body parts
clear of this area.
Fan hazard; keep body
parts clear of this area.
Crush hazard; keep
body parts clear of
this area.
Do not operate near
power lines. Contact with
power lines can cause
electrocution.
Do not remove guard.
Fire/explosion hazard;
keep open flames
away from unit.
Automatic Start.
Non-potable water.
00901
9
Advertisement
Table of Contents
