Safety Symbol Summary - Generac Power Systems Magnum MTT25 Operating Manual

SAFETY SYMBOL SUMMARY

This equipment has been supplied with numerous safety and operating decals. These decals provide important
operating instructions and warn of dangers and hazards. Replace any missing or hard-to-read decals and use care
when washing or cleaning the unit. Decal placement and part numbers can be found in the parts manual. Below is
a summary of the intended meanings for the symbols used on the decals.
Safety alert symbol; used to
alert you to potential personal
injury hazards.
Hot surface(s) nearby.
Belt/entanglement hazard; keep
body parts clear of this area.
Fan hazard; keep body parts
clear of this area.
Crush hazard; keep body parts
clear of this area.
Ultraviolet radiation hazard;
UV
operate only with lens intact.
Stop engine before fueling.
Fire/explosion hazard; keep
open flames away from unit.
Never change switch position
while engine is running.
Engine running.
Do not stand on this surface.
Do not drink the water.
Stand clear while mast
is being operated.
Asphyxiation hazard; operate
in well ventilated area.
Dangerous voltage may be
present.
Anchor/tie down point.
Isolate generator to prevent
electrocution hazard.
Use clean diesel fuel only.
Burn/scald hazard;
pressurized steam.
Read and understand the
supplied operator's manual
before operating unit.
Unit electrical ground.
Stop engine before making
connections.
Remove negative battery
cable before performing
any service on unit.
Do not step on this surface.
Do not lift.
Stay out of tank.
00199
9