Preset Operation - Martin Audio SX110 User Manual

SX SERIES USER GUIDE
SXP218

Preset Operation

SXP218 can be fully configured using VU-NET on an Ethernet network. Alternatively plug-and-play operation is available using factory
presets selected using the preset button on the connector panel.
Preset 1 - SXP218 used in conjunction with CDD-LIVE12 or CDD-LIVE15:
Preset 2 - SXP218 used in conjunction with CDD-LIVE8:
Preset 3 - SXP218 used in conjunction with CDD-LIVE12 or CDD-LIVE15 in cardioid (rear facing) mode:
Preset 4 - SXP218 used in conjunction with CDD-LIVE8 in cardioid (rear facing) mode:
Note that the selected preset is retained after powering down the SXP218. The same preset will still be selected when you next power-up
the cabinet.
When a system is connected to VU-NET via the Ethernet ports the preset LEDs will be extinguished to show that the system settings may
have been changed. To restore the preset once VU-NET is disconnected press the preset button until it has cycled round to the preset you
require. Any changes made in VU-NET will then be overwritten with the factory setting.
Meter Mode
An additional feature is meter mode which is selected by pressing and holding the preset select button for two seconds. In this mode the
LEDs which normally indicate which preset has been selected, become an input level bar graph to show level applied to the speaker. To
return to normal preset selection, press and hold again for two seconds.
75
Copyright © 2019 Martin Audio Ltd. SX SERIES USER GUIDE V1.0