Weather Kit - Martin Audio SX110 User Manual

SX SERIES USER GUIDE
SX118

Weather Kit

The WRKIT for non-powered SX Series subwoofers is a glanded cover which fits over the connection panel to prevent water ingress
protecting the NL4 speaker connection.
The cable entry may be through one of two knock-out positions depending the angle from which you wish the cable to enter. First remove
the knock-out blank that you wish to use and fit the cable gland in position. Note that to use the WRKIT it is necessary to remove the NL4
connector from your speaker cable so the cable can be fed through the cable gland. Once the cable has been threaded through the gland
the NL4 can be re-attached.
Remove the four counter-sunk screws in the connector panel and position the cover on the connector panel. Connect the NL4 to the input
connector and position the cover, pulling the slack in the speaker cable as you lower the cover in position. Secure the cover using the four
M4 x 25 cap socket screws and fibre washers. Finally tighten the gland to ensure a waterproof seal.
32
Copyright © 2019 Martin Audio Ltd. SX SERIES USER GUIDE V1.0