Memory Bank Scanning; Memory Bank Link Scanning; Setting Bank Link; Performing Bank Link Scan - Yaesu FT3DR Advanced Manual

Memory Bank Scanning

Scan only the memory channels stored in the recalled memory bank.
1. Recall the memory bank you want to scan by referring to "Open the Memory Bank
display" (page 18) and "Open Memory Bank Channels" (page 18).
2. Touch [F MW]  [SCAN].
If [SCAN] is not displayed, touch [BACK ←] to display [SCAN] and then touch it.
Memory bank scan starts.

Memory Bank Link Scanning

During regular memory bank scanning, only the memory channels assigned to the re-
called memory bank are scanned. During memory bank link scanning, you can scan
memory channels registered in two or more banks you specified in advance.

Setting Bank Link

1. Press and hold the [DISP] key  touch [MEMORY]  [1 BANK LINK].
2. Rotate the DIAL to select the memory bank for which you want to perform bank link
scanning.
3. Press the [DISP] key, a check mark will appear and it will be set to Bank Link.
4. Repeat steps 3 and 4 to select other memory banks.
5. Press the PTT switch to save the setting and return to normal operation.

Performing Bank Link Scan

1. Recall the memory bank set as bank link by referring to "Open the Memory Bank dis-
play" (page 18) and "Open Memory Bank Channels" (page 18).
The memory bank number is changed from [B] to [b] and the bank link scanning is
activated.
2. Touch [F MW]  [SCAN].
If [SCAN] is not displayed, touch [BACK ←] to display [SCAN] and then touch it.
Bank Link Scanning is performed toward the higher memory channel numbers.
Press and hold the [DISP] key  touch [SCAN]  [5 SCAN WIDTH]  [BANK LINK] is set
to "OFF", to temporarily disable banklink and perform normal memory-bank scanning while
banklink is set.
23