Johnson Controls VMA 1410 Overview And Engineering Manuallines page 28

28 VMA1400 Series Overview and Engineering Guidelines Technical Bulletin
Feature (Cont.)
Standards
Compliance
Accessories
Specification
CSA C22.2 No. 205
UL916, UL864 (UUKL), UL94-5VB
FCC CFR47 Part 15, Subpart B, Class A and B Verified
C-tick Australia, AS/NZS 4251.1
CE EMC Directive 89/336/EEC, (EN 50081-1, CISPR 11, Class B, EN 50082-2)
IEEE 472, IEEE 518, IEEE 587 Category A/B
AP-TBK1002-0* Removable 2-position screw terminal kit (100 pcs)
AP-TBK1003-0* Removable 3-position screw terminal kit (100 pcs)
M9000-106* Removable 4-position screw terminal (1 piece each)
AP-TBK4N2-0 Replacement N2 Bus 4-position screw terminal kit (10 pcs)
* These terminals fit over the existing I/O spade lugs.
Federal Communications Commission Part 15 Label
This equipment has been tested and found to comply with the limits
for a Class A digital device pursuant to Part 15 of FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when this equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is
likely to cause harmful interference, in which case the user will be
required to correct the interference at his/her own expense.