Specifications - Sony MHC-RX100AV Operating Instructions Manual

Specifications

Amplifier section
DIN power output
Continuous RMS power output
Music power output
Inputs
48
FRONT SPEAKER:
50 + 50 watts (8 ohms, at
1 kHz)
REAR SURROUND
SPEAKER:
10 + 10 watts (16 ohms, at
1 kHz)
CENTER SURROUND
SPEAKER:
20 watts (8 ohms, at 1
kHz)
FRONT SPEAKER:
70 + 70 watts (8 ohms, at
1 kHz, 10% THD)
REAR SURROUND
SPEAKER:
12.5 + 12.5 watts (16
ohms, at 1 kHz, 10%
THD)
CENTER SURROUND
SPEAKER:
25 watts (8 ohms, at 1
kHz, 10% THD)
FRONT SPEAKER:
105 + 105 watts (8 ohms,
at 1 kHz, 10%THD)
REAR SURROUND
SPEAKER:
20 + 20 watts (16 ohms, at
1 kHz, 10% THD)
CENTER SURROUND
SPEAKER:
45 watts (8 ohms, at 1
kHz, 10% THD)
VIDEO/MD IN (phono
jacks): voltage 250 mV,
impedance 47 kilohms
MIX MIC (phone jack):
sensitivity 1 mV,
impedance 10 kilohms
Outputs
CD player section
System
Laser
Laser output
Frequency response
Wavelength
Signal-to-noise ratio
Dynamic range
CD OPTICAL DIGITAL OUT
(Square optical connector jack, rear panel)
Wavelength
Output Level
Tape player section
Recording system
Frequency response
(DOLBY NR OFF)
Wow and flutter
VIDEO/MD OUT (phono
jacks): voltage 250 mV
impedance 1 kilohms
PHONES (stereo phone
jack): accepts headphones
of 8 ohms or more.
FRONT SPEAKER:
accepts impedance of 8 to
16 ohms.
REAR SURROUND
SPEAKER:
accepts impedance of
18ohms.
CENTER SURROUND
SPEAKER:
accepts impedance of 8
ohms.
SUPER WOOFER:
voltage 1V, impedance 1
kilohm
Compact disc and digital
audio system
Semiconductor laser
( =780nm)
Emission duration:
continuous
Max. 44.6 W*
*This output is the value
measured at a distance of
200 mm from the
objective lens surface on
the Optical Pick-up Block
with 7 mm aperture.
2 Hz – 20 kHz (±0.5 dB)
780 – 790 nm
More than 90 dB
More than 90 dB
600 nm
–18 dBm
4-track 2-channel stereo
60 – 13,000 Hz (±3 dB),
using Sony TYPE I
cassette
60 – 14,000 Hz (±3 dB),
using Sony TYPE II
cassette
±0.15% W.Peak (IEC)
0.1% W.RMS (NAB)
±0.2% W.Peak (DIN)