Tape Deck - Sony MHC-RX100AV Operating Instructions Manual

Tape Deck

The tape does not record.
•No tape in the cassette holder.
•The tab has been removed from the
cassette (see "To save a tape
permanently" on page 44).
•The tape has reeled to the end.
The tape does not record nor play or there
is a decrease in sound level.
•The heads are dirty. Clean them (see
"Cleaning the tape heads" on page 45).
•The record/playback heads are
magnetized. Demagnetize them (see
"Demagnetizing the tape heads" on page
45).
The tape does not erase completely.
•The record/playback heads are
magnetized. Demagnetize them (see
"Demagnetizing the tape heads" on page
45).
There is excessive wow or flutter, or the
sound drops out.
•The capstans or pinch rollers are dirty.
Clean them (see "Cleaning the tape
heads" on page 45).
Noise increases or the high frequencies are
erased.
•The record/playback heads are
magnetized. Demagnetize them (see
"Demagnetizing the tape heads" on page
45).
Tuner
Severe hum or noise ("TUNED" or
"STEREO" flashes in the display.
•Adjust the aerial.
•The signal strength is too weak. Connect
the external aerial.
A stereo FM programme cannot be
received in stereo.
•Press STEREO/MONO so that "STEREO"
appears.
If other troubles not described
above occur, reset the system as
follows:
1 Unplug the power cord.
2 Plug the power cord back in.
3 Press SPECTRUM ANALYZER, ENTER/
NEXT, and DISC 1 at the same time.
47