Specifications - Sony CMT-HP7 Operating Instructions Manual

Cleaning the cabinet
Cleml the cabinet, panel and controls with a soft cloth
sligbtly moistened with mild detergent sokaion. Do not
use any type of abrasive pad, scotu-ing powder or
solvent such as thilmer, benzene or alcohol.
To save a tape permanently
To prevent a tape fiom being accidentally recorded
over, break off the cassette tab fi-om side A or B as
illusu_te&
If you later wata to reuse the tape tbr recording, cover
the broken tab with adhesive tape.
Before placing a cassette in the tape
deck
Takeup any slackin thetape.Otherwise,the tapemay
get entangled in the parts of the tape deck and become
damaged.
When using a tape longer than
90 minutes
The tape is very elastic. Do not change the tape
operations such as play, stop, mid fast-winding
frequently. The tape may get entangled in the tape
deck.
Cleaning the tape heads
Cleml the tape heads after every 10 hours of use. Be
sure to clean the tape beads before you stm_ an
important i_ecordingor after playing an old tape. Use a
separately sold dry-type or wet-type clemling cassette.
For details, lefer to the ilknmctions of the clemling
cassette.
Bernagnetising the tape heads
Demagneti_ the tape heads and the metal parts that
have contact with the tape after every 20 to 30 hours of
use with a separately sold demagmetising cassette. For
details, l_eferto the instructions oftbe d_aaguetising
cassette.
Main unit
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
With 6 ohm loads, both chapels driven, from
120 - 10,000 Hz: rated 60 watts per channel
minimum RMS power, with no more than 10%
total harmoff_c distortion from 250 miniwatts to
rated output.
Amplifier section
North American model:
Cxmtinuous RMS power output 0_eference):
60 + 60 watts (6 ohms at I
kHz, 10% THD)
Total harmonic diatoriion less than 0.7% (6 ohms at 1
knz, 30 W)
European and Russian models:
DIN power outp_ (rated): 60 + 60 watts (6 ohms at I
kHz, DIN)
Cxmtinuous RMS power output (i_eference):
60 + 60 watts (6 ohms at I
kHz, I0% THD)
Music power output (reference):
120+ 120watts (6 ohms at
1 kHz, 10% THD)
Other models:
The thllowing measured at AC 120, 127, 220, 240 V
50/60 Hz
DIN power outp_ (rated): 60 + 60 watts (6 ohms at 1
kHz, DIN)
Continuous RMS power output (reference):
60 + 60 watts (6 ohms at 1
kHz, I0% THD)
Inputs
MD IN (phono jacks):
Sensitivity 250 mV,
impedance 47 kilohms
Outputs
PHONES (stereo minijack):
accepts headphones of 8
ohms or more
OPTICAL CD DIGITAL OUT (Supported sampling
frequency: 44.1 kHz)
SPEAKER: accepts impedance of 6 to
16 ohms.
32 c*