Table of Contents
Advertisement
NOTE fOR OTHER ADSL SERVICE PROVIDER USERS:
Basic PPP0E set-up on IAD for ADSL modem without NAT (Network Address Translation)
To perform basic PPP0E configuration on Linksys SPA2102-R3 IAD:
1.
Using an Ethernet RJ45 Cable, connect your PC to the Linksys SPA2102-R3 IAD Ethernet Port.
2.
Start a Web browser such as Microsoft® Internet Explorer or Netscape Navigator®.
3.
Go to START-> RUN, key in "cmd". The command prompt window will pop up
At the command prompt key in "IPCONFIG". You will be able to see the Default Gateway IP address.
Using the Default Gateway IP address "192.168.1.1", copy the IP address and paste it at your Internet browser
and it will enable you to launch the customize webpage as shown in the screen capture below.
* Note the default IP address will be "192.168.0.1".
Setting Up Your Digital Voice Global Connection
11
Advertisement
Table of Contents
