Table of Contents
Advertisement
How to connect Digital Voice Global using a cable or ADSL connection
with built-in router.
Steps for Setting up:
1.
Ensure that your IAD is unplugged and that the power supply to your modem is turned off.
2.
Connect one end of an Ethernet cable (RJ-45) to an open Ethernet LAN port on your modem with
built-in router. Connect the other end of this Ethernet cable to the WAN connector on your IAD.
3.
Connect a telephone to your PHONE 1 connector on your IAD using a RJ-11 telephone cable.
4.
Power on your modem. Wait for about 2 minutes for it to start up.
5.
Plug the AC power adapter to the POWER connector on your IAD and the electrical outlet.
This turns your IAD on.
Note: You should keep the IAD powered on all the time in order to receive incoming calls.
6.
Wait for about 2-5 minutes for the IAD to start up
Note: Start-up may take longer if the IAD re-configuration takes place or when the Internet is slow/congested.
7.
Pick up the telephone handset and listen for a dial tone. If you hear a dial tone, you can now call anyone
as you normally would on any telephone. If you do not hear a dial tone, check that all connections as
described in this procedure are correct.
Setting Up Your Digital Voice Global Connection
9
Advertisement
Table of Contents
