Port Enable Settings
Carrying out port enable settings
Use the following procedure to enable and disable ports.
1
2
Note
When you save setup data, the port enable settings are saved as part of the
setup data in the non-volatile memory or on a floppy disk. Therefore, when
the unit is powered on or reset with the resume functon being "off", the port
enable settings are read from the memory before the system starts. Note that
it is not possible to save port enable settings in a snapshot data.
For details of saving and recalling setup data, see page 14-2.
12-4
Chapter 12 MISC Menu Operations
In the MISC menu, select item 1 (ENABLE).
The ENABLE menu appears.
DME1
DME2
GPI
ENBL
ENBL
ENBL
F1
F2
F3
Function key indications in the ENABLE menu
Press any of F1 to F7, toggling it between "ENBL" (for enable) and
"DSBL" (for disable).
F1 (GPI): switcher and DMK GPI ports
F2 (DME1) to F5 (DME4): switcher ports DME1 to DME4
F6 (EDIT A): switcher EDITOR A or DMK EDITOR port
F7 (EDIT B): switcher EDITOR B port
F8 (SWER PANEL 2): switcher PANEL 2/REMOTE 3 port
F9 (DMK PANEL B): DMK PANEL B port
The F6 and F7 indications depend on the settings in the PORT ASSIGN
menu (see page 14-46). In particular, when the F6 indication is "DME5"
or "REMOTE1", it is not possible to make settings for the DMK
EDITOR port.
DME3
EDIT A
EDIT B
DME4
ENBL
ENBL
ENBL
ENBL
F4
F5
F6
F7
SWER
DMK
PANEL 2
PANEL B
TABLET
ENBL
ENBL
OFF
F8
F9
F10