Adjusting The Handle Height; Adjusting The Cutting Height - Toro Recycler 20373 Operator's Manual

Adjusting the Handle Height

You can raise or lower the handle in 1 of 2 positions that is
more comfortable for you
1. Loosen both handle knobs until you can push the
square edges of the carriage bolts out of the square
holes in the handle brackets.
2. Push the knobs until they are loose.
3. Move the handle to the upper or lower height position.
4. Pull the knobs until the square edges of each carriage
bolt fits into its related square hole.
5. Tighten the handle knobs as tight as you can.

Adjusting the Cutting Height

WARNING
If the engine has been running, the muffler will be
hot and can severely burn you.
Keep away from the hot muffler.
Adjust the cutting height as desired. Set all the cutting-height
levers to the same height. To raise and lower the machine,
refer to Figure 16.
(Figure 15).
Figure 15
g195422
1. Raise the machine
1. Front cutting height lever
2. Rear cutting height lever
3. 25 mm (1 inch)
4. 35 mm (1-3/8 inches)
5. 44 mm (1-3/4 inches)
6. 54 mm (2-1/8 inches)
10
Figure 16
2. Lower the machine
Figure 17
7. 64 mm (2-1/2 inches)
8. 73 mm (2-7/8 inches)
9. 83 mm (3-1/4 inches)
10. 92 mm (3-5/8 inches)
11. 102 mm (4 inches)
g195426
g195425