Setup; Assembling And Unfolding The Handle; Figure - Toro Recycler 20373 Operator's Manual

Setup

Important: Remove and discard the protective plastic
sheet that covers the engine and any other plastic or
wrapping on the machine.
1
Assembling and Unfolding the
Handle
No Parts Required
Procedure
1. Remove and save the 2 handle knobs and 2 carriage
bolts from the handle brackets
1. Handle knob (2)
2. Install the handle ends onto the mower housing so that
the pin attached to each handle bracket is in the lower
hole of its related handle end
1. Pin

(Figure

4).
Figure 4
2. Carriage bolt (2)
(Figure 5).
Figure 5
2. Handle end
Note: The pins do not show through the holes in the
handle ends when the handle is in the folded position.
3. Unfold the handle to the operating position by rotating
it rearward
1. Operating position
4. Insert the carriage bolt (with the bolt head toward
the inside) through the upper or lower square hole in
handle bracket and the upper hole in the handle end
(Figure 7).
g195430
1. Handle knob
5. Loosely install the handle knobs onto the carriage bolts.
6. Refer to steps 3 through 5 of
Height (page
g032866
5
(Figure 6).
Figure 6
2. Folded position
Figure 7
2. Carriage bolt
Adjusting the Handle
10).
g195431
g032869