Siemens SIMATIC MOBY D System Manual page 285

11.2 Error messages and causes for MOBY D with ASM and FC/FB 45 (direct MDS addressing)
Error code in
HEX
06
0A
0B
0C
0D
0F
10
11
12
13
MOBY D
System Manual, 01/2010, J31069-D0147-A6-7618
Flashing of Cause, remedy
ERR LED
6x Field interference on SLG
The SLG is receiving interference from its environment.
MDS has left the field during communication.

Communication between SLG and MDS has been interrupted by

external interference.
The distance between two write/read devices is too small and does

not correspond to the configuration guidelines
Antenna error
Antenna is unscrewed

10x Only during initialization: MDS is unable to perform the initialization
command.
MDS is defective.

11x Memory of MDS cannot be read correctly.
12x Memory of the MDS cannot be write-accessed.
Memory of the MDS is defective.

13x Address error (address range overshoot)
Specified address does not exist on MDS

The command must be checked and corrected when the message

frame is created
The MDS is not the right type.

15x Start message
This message is output by the ASM after every start. (A start occurs
after connection of the operating voltage, after operating the front
switch, after a rest via the X1 connector or following a bus error.) The
start message remains active until the user issues a RESET command
to the ASM. This enables the user to detect reconnection to the power
supply (and therefore operational readiness) on the ASM.
Execute an init_run

16x NEXT command is not possible.
SLG does not recognize NEXT command.

17x Short-circuit or overloading of 24 V outputs
Next command must be a RESET command.
The affected output is turned off.

All 24 V outputs are turned off when total overload occurs.

A reset can only be performed by turning the power supply off and

on again.
Then start init_run.

18x Internal ASM communication error
Connector contact problem on the ASM (send in ASM for repairs)

ASM hardware defect

Electromagnetic interference

Start init_run command after error correction.

19x ASM/SLG does not have enough buffer to store the command
intermediately.
Alarm, error and system messages
285