Specifications - Aiwa XR-EM70 Operating Instructions Manual

Specifications

MAIN UNIT CX-LEM70
TUNER
FM tuning range 87.5 MHz to 108 MHz
FM usable sensitivity (IHF) 13.2 dBf
FM antenna terminal 75 ohms (unbalanced)
AM tuning range 530 kHz to 1710 kHz (10 kHz step)
531 kHz to 1602 kHz (9 kHz step)
AM usable sensitivity 350 µV/m
AM antenna Loop antenna
AMPLIFIER
Power output 28 W + 28 W (40 Hz - 20 kHz, THD
less than 1%, 6 ohms)
35 W + 35 W (1 kHz, THD 10 %, 6
ohms)
Total harmonic distortion 0.15 % (17.5 W, 1kHz, 6 ohms, DIN
AUDIO)
Input AUX IN: 700 mV
Outputs SPEAKERS: 6 ohms or more
PHONES: 32 ohms or more
DIGITAL OUT (OPTICAL) jack
CASSETTE DECK
Track format 4 tracks, 2 channels stereo
Frequency response 50 Hz – 15000 Hz
Recording system AC bias
Heads Recording/playback 1, erase 1
CD PLAYER
Laser Semiconductor laser ( = 780 nm)
D/A converter 1 bit dual
Signal-to-noise ratio 88 dB (1 kHz, 0 dB)
Harmonic distortion Unmeasurable (1 kHz, 0 dB)
Wow and flutter Unmeasurable
GENERAL
Power requirements 120 V AC, 60 Hz
Power consumption 60 W
Power consumption in standby mode
With ECO mode on or AUTO: 0.7 W
With ECO mode off: 14 W
Dimensions (W H D) 191.5 249.0 389.0 mm
(7 5 / 9 7 /
8 8
Weight 5.3 kg (11 lbs 12 oz)
SPEAKER SYSTEM SX-LEM70
Speakers system 2 way, bass reflex (magnetic
shielded)
Speaker units Woofer: 120 mm (4
Tweeter: 25 mm (1 in.) dome
Impedance 6 ohms
Dimensions (W H D) 155 250 218 mm
(6 1 / 10 8
8
Weight 2.4 kg (5 lbs 6 oz)
Specifications and external appearance are subject to change
without notice.
COPYRIGHT
Check copyright laws relevant to recordings from discs, radio
or tape for the country where the unit is to be used.
NOTE
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the
15 3 / in.)
8
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
7 / in.) cone
8
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
5 / in.)
interference by one or more of the following measures:
8
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on circuit different from
that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
CAUTION
Modifications or adjustments to this product, which are
not expressly approved by the manufacturer, may void the
user's right or authority to operate this product.
En
19