HP Adaptive Rack Cooling System System Installation Manual page 13

WARNING: To avoid tipping the HPE Adaptive Rack Cooling System over, be sure that the
leveling feet are lowered when the HPE Adaptive Rack Cooling System is equipped, serviced,
and operated.
6. Connect the network cable to the RJ-45 connector (labeled "ETH") on the transfer switch at the top
right on the rear of the HPE Adaptive Rack Cooling System.
7. Plug the other end of the network cable into the facility network connection outlet.
WARNING: Before connecting the power cords to a power source, be sure that the unit is
properly grounded for potential equalization caused by high leakage current.
IMPORTANT: Do not connect the power cords into a power source before connecting to the
HPE Adaptive Rack Cooling System.
8. Plug the primary power cord into the power connector on the left at the power distribution inside the
HPE Adaptive Rack Cooling System.
Installation 13