Table of Contents
Advertisement
1.
INSTALLATION
Note: Installation must comply with the local regulation!
Procedure:
1.
Choose a place where is dry, clean, flat and firm for controller installation.
2.
Choose a proper installation location to make sure the front door can be opened smoothly.
3.
Mark 4 installation holes with pen on the wall for drilling. (Fig. 2-1)
4.
Drill the holes, put expansion bolts in and insert the M6 screws.
5.
Break the cable entries on the controller.
6.
Hang the controller over those screws.
7.
Insert cables into the controller.
8.
Open the front panel and tighten the screws to fix the controller on the wall.
9.
Connect cables to the terminals according to Fig. 2-2, 2-3, 2-4, 2-5, 2-6, 2-7, 2-8.
10. Install and secure the batteries properly.
11. Close the front panel. Lock it with special tools and store the tools in a safe place.
Operating Manual of FC18 Controller
CHAPTER 2 INSTALLATION
Fig. 2-1 Installation size (In: mm)
500
Page: 8/70
Hide quick links:
Advertisement
Table of Contents
