Installing The Logs - Superior VRE3236ZENWS Installation And Operation Instructions Manual

Install the Logs and Glowing Embers
• Turn OFF all gas and electricity to the appliance before installing the embers, and logs.
• Do NOT install the logs until the appliance has been completely installed, the gas line connected and
tested for leaks, and the initial burner operation has been confirmed.
• Use of an unapproved log set in the fireplace will void the warranty and will result in incomplete
combustion, sooting, and poor flame quality.
• Logs get very hot and will remain hot up to one hour after gas supply is turned off. Handle only when
logs are cool. Turn off all electricity to the appliance before you install grate and logs.
• This appliance is not designed to burn wood. Any attempt to do so could cause irreparable damage to
appliance and prove hazardous.
• If the logs are not installed according to these instructions, improper combustion could occur. This
could result in the excessive production of soot and/or the colorless, odorless, toxic gas carbon
monoxide (CO).
• The size and position of the log set was engineered to give your appliance a safe, reliable and
attractive flame pattern. Any attempt to use a different log set in the fireplace will void the warranty
and will result in incomplete combustion, sooting, and poor flame quality.
NOTE: It is important to ensure proper log placement per the manual when installing these units. Verify pilot flame is not
obstructed. See Verifying Appliance Operation on Page 42.
WARNING
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
11