Connecting An Antenna/Cable Tv System To A Vcr - Sony KP 53HS10 Operating Instructions Manual

Connecting an Antenna/Cable
TV System to a VCR
1
Attach the coaxial cable from the incoming
cable connection or antenna to IN on the VCR.
2
Using a coaxial cable, connect OUT on the
VCR to VHF/UHF on the projection TV.
3
Using AUDIO and S VIDEO* cables, connect
AUDIO and S VIDEO OUT on the VCR to
AUDIO and S VIDEO IN on the projection TV
(White-AUDIO Left, Red-AUDIO Right).
* If your VCR is not equipped with S VIDEO, use
a VIDEO cable (yellow) instead of the S VIDEO
cable.
Note:
• If you are connecting a monaural VCR, connect
only the single audio output to the left (MONO)
input on the projection TV.
(Rear of projection TV)
CONTROL S
IN OUT
IN
VIDEO 1 VIDEO 3
S VIDEO
VIDEO
L
(MONO)
AUDIO
R
VIDEO
AUDIO-L
S VIDEO
AUDIO-R
VMC-810S/820S
(not supplied)
YC-15V/30V (not supplied)
Disconnect all power sources before making any connections.
AUX
IN OUT
SELECT
VIDEO 4 VIDEO 5 (DTV)
HD VD
VHF/UHF
Y Y/G
VIDEO
L
P P /B (MONO)
B B
Coaxial cable
L
(not supplied)
AUDIO
R
P P /R
R R
R
COMPONENT AUDIO
VCR
AUDIO R AUDIO L VIDEO
LINE
IN
LINE
OUT
2
1
S VIDEO
Cable/
VHF/UHF
Antenna
OUT
IN
3
9