Using With Axs-R7 - Sony VENICE MPC-3610 Operating Instructions Manual

000 27
2. Preparation

Using with AXS-R7

You can record video/audio in RAW or X-OCN
to an AXS-R7 AXS (Access Memory Card System)
Recorder (optional) by attaching the recorder to
the unit.
[Note]
To attach an AXS-R7 to the unit, the firmware version of the
AXS-R7 may need to be updated according to the version
of the unit (page 29). The following shows the version
compatibility.
Version of unit Version of AXS-R7
1.0, 1.01 1.1
2.01 2.0
3.0 3.0
4.0 4.0
Attaching the AXS-R7
[Note]
Attach/remove the AXS-R7 while the unit is turned off.
1
Unscrew the four hex screws (3 mm) on the
rear of the unit, and remove the battery plate.
Battery plate
2
Unscrew the four hex screws on the rear of the
AXS-R7, and remove the docking module from
the AXS-R7.
Docking module
AXS-R7
3
Attach the AXS-R7 to the unit, and tighten the
four hex screws.
AXS-R7
To remove the AXS-R7
Unscrew the four hex screws, and remove the
AXS-R7.
Inserting an AXS Memory Card
1
Press the memory card slot cover open button
to open the cover.
2
Insert the AXS memory card into the card slot
with the label facing as indicated below.
Label
3
Close the cover.
Switching Between AXS Memory
Cards
When two AXS memory cards are loaded, press
the SLOT SELECT button of the AXS-R7 to switch
active slot.
SLOT SELECT button
Removing an AXS Memory Card
Open the memory slot cover of the AXS-R7, and
pull out the AXS memory card.
[Note]
Data integrity is not guaranteed if the power is turned off or
an AXS memory card is removed while it is being accessed.
Data on the card may be destroyed. Be sure that its ACCESS
lamp is lit in green or off when you turn off the power or
remove a memory card.