Vddio Interface Header - J16 - Texas Instruments DS90UB954-Q1EVM User Manual

DS90UB954-Q1EVM Board Configuration -Evaluation Board Connections
3.7 Control Interface
Reference
J16
Reference
J22.1
J22.3
J22.5
J22.7
J22.9
J22.11
J22.13
J22.15
Reference
TP16
TP17
Reference
J15.1
J15.2
J15.3
J15.4
(1)
Only set one ON.
(2)
This function is only available with 2-MP ADAS chipsets.
Reference
J11.1
J11.2
J11.3 VDD_SEL
J11.4
10
DS90UB954-Q1EVM Quick Start
Table 7. VDDIO Interface Header - J16
Signal
Selects VDDIO bus voltage
VDDIO Short pins 1-2: 3.3V IO (Default)
Short pins 2-3: 1.8V IO
Table 8. GPIO Interface Header - J22
Signal
GPIO0 General Purpose Input/Output 0
GPIO1 General Purpose Input/Output 1
GPIO2 General Purpose Input/Output 2
General Purpose Input/Output 3 / Interrupt (Active Low).
GPIO3/INTB
Pulled up to VDDIO by 4.7kΩ
GPIO4 General Purpose Input/Output 4
GPIO5 General Purpose Input/Output 5
GPIO6 General Purpose Input/Output 6
EN 25MHz Enable/Disable 25MHz Oscillator
Table 9. CMLOUTP Output Signals
Signal
CMLOUTP Test Pad for Channel Monitor Loop-through Driver
CMLOUTN Test Pad for Channel Monitor Loop-through Driver
Table 10. FPD-Link III Mode Control- J15
Mode
1 CSI Mode (DS90UB953-Q1 compatible)
2 RAW12 / LF (DS90UB933 compatible)
3 RAW12 / HF (DS90UB933 compatible)
4 RAW10 (DS90UB933 compatible)
Table 11. Device Mode Control - J11
Signal Input = L
For Normal operation
BISTEN
(Default)
RSVD Tied to GND (Default)
Internal 1.1V regulator from
1.8V supply (Default)
PDB Device is powered down
Copyright © 2017, Texas Instruments Incorporated
Description
Description
Description
(1)
Description
(2)
Input = H
Test Mode enable
N/A
1.1V is supplied to VDD1V1
pins
Device is enabled (Default)
Submit Documentation Feedback
www.ti.com
Description
Test Mode
Reserved
VDD 1.1V Source Select
Power-down Mode
SNLU223 – August 2017