Table of Contents
Advertisement
6.4.14. Network Setting
The Network Settings is used to enable or disable IPv6 (Internet Protocol version 6).
IPv6 is set to "Enable" as default.
Double-tap the Network Settings icon in the System Properties
Specifying LAN/WLAN Metric
- Note -
s
System Properties
Follow the steps below.
Step 1 Select either "Enable" or "Disable".
Enable: IPv6 is activated.
Disable: IPv6 is deactivated.
Step 2 Tap the Apply button.
To cancel the change, tap the Cancel button.
Step 3 Tap the OK button on the right corner of the message.
- Note -
The changes take effect after a reset (warm boot).
In the LAN and the WLAN tab menus, the network connection priority of
LAN or WLAN can be changed.
Automatic metric:
Specifies whether TCP/IP automatically calculates a value for an
interface metric that is based on the speed of the interface.
The highest-speed interfacehas the lowest interface metric value.
Check the box to enable the automatic metric. (default: checked)
Interface metric:
Provides a location for you to type a value for the interface metric for this
network connection. A lower value for the interface metric indicates a
higher priority for use of this interface.
* The LAN communication via a cradle Lan for the BHT is scheduled to be
upgraded. Please contact your dealer for details.
- 80 -
Advertisement
Table of Contents
