Table of Contents
Advertisement
3.7. Using the MENU key
Page 1
Page 2
The MENU key is used to set up the BHT basic configuration listed
below.
Step 1 Press the MENU key.
Step 2 Select the menu by moving the cursor vertically with the ▲ (up)
or ▼ (down) keys.
The selected menu is highlighted.
Step 3 Set the menu by moving the cursor horizontally by using the ◄
(left) or ► (right) keys.
To exit this menu, press any one of the three keys, the MENU key, the
ESC key or the ENT key.
Menu
BEEPER
Adjusts the notification beeper volume
VOLUME
for code scanning completion.
The volume is adjustable in 6 levels.
0: Mute, 1(Low) to 5 (High)
Note: Use the "Volume & Sounds" in the
control panel to adjust the audio sound
volume and change other sound
settings.
Enables or disables the vibrator to notify
VIBRATOR
code scanning completion.
BRIGHTNESS
Adjusts the LCD brightness in 4 levels.
BRIGHTNESS
Changes the LCD brightness for the
power save mode in 2 levels.
(PS)
Set the time for the LCD backlight to dim
POWER SAVE
when the BHT is not in use.
Use the slider to set the time.
RESET/FULL
Performs a reset or full reset.
RESET
Note: Use the "Reset" menu in the
System Properties to disable the reset
and full reset functions.
(BhtShell>3:System Properties>Reset)
TOUCH PANEL Enable or disable the touch panel.
Set the auto power off timer.
AUTO
If "0" is set, the auto power off function is
POWER-OFF
disabled. Check the battery level
TIME
regularly if set to "0".
- 16 -
Description
Value
Level 0 to 5
ON or OFF
Level 0 to 3
Level 0 or 1
Set the time
in seconds.
(max.600
seconds)
None
ON or OFF
Set the time
in seconds.
(max.600
seconds)
Advertisement
Table of Contents
