Table of Contents
Advertisement
6.10. Scanner Re
The setup menu for the scanner reading parameters is launched from the System
Properties or the Test menu in the System menu.
6.10.1. Read Mode
Auto-off mode
The illumination LED turns on when the trigger key is pressed, and turns off when the trigger key is released or
a code is read.
The illumination LED turns
When the illumination LED
The BHT reads a code while the
When a first code is read successfully
In order to read the next code, read ou
Momentary switching mode:
Only while the trigger key is held down, the illumination LED turns on and the BHT can read a code.
The illumination LED does not turn back on by pressing the trigger key thus, the BHT does not read the next
code, unless the scanned data is read out from the barcode buffer.
ading Pa
rameters
u
se the settings:
Read Mode:
Read Code:
D
ata Edit:
O
K button:
Cancel button:
The Read Mode menu is used to set the scanner reading mode.
Select one from the following 4 modes.
Auto Off:
M
omentary:
A
lternate:
C
ontinuous:
B
eeper:
on continu
ously for a maximum of 5 seconds while the trigger key is pressed.
turns off a
fter 5 seconds has elapsed, press the trigger key again.
illum
ination LED is turned on.
or
the code device file is closed, the BHT no longe
t the scanned
Enables or disables the menu.
Default is unchecked (disabled).
Sets the scann
er reading mode.
Sets up the read
Edits data read by the scanner.
Exits the menu.
The new settings takes effect after the OK button is
pressed, and are stored in the registry.
Aborts the changes and exits the menu.
Auto-Off mode
Momentary switching mode
Alternate switching mode
Continuous reading mode
Activates the beeper and or vibrator when the
scanning is completed.
data from the code buffer, then press the trigger key again.
- 116 -
able codes.
r reads a code.
Advertisement
Table of Contents
