Appendix 4: Parameter List Level 1 & Level 2 (Pr1 & Pr2) - Emerson Copeland EazyCool ZXDI Series Application Manuallines

Appendix 4: Parameter list Level 1 & Level 2 (Pr1 & Pr2)
Legend
L1 = Parameter in Level 1 (without password)
L2 = Parameter in Level 2 (with password = 3 2 1)
N.V. = Parameter not accessible
NOTE: When changing parameter C05 (LS) a reset of the controller (interruption of power supply) is required.
Parameters
ZXDE ZXDI
A01 P1C Probe P1 configuration
A02 P1i Start of scaling for probe 1 (0-5V)
A03 P1E End of scaling for probe 1 (0-5V)
A04 P1F Probe P1 calibration
A05 P1d Probe P1 reading error delay (P1C=0-5V)
A06 P2C Probe P2 configuration
A07 P2i Start of scaling for probe 2
A08 P2E End of scaling for probe 2
A09 P2F Probe P2 calibration
A10 P2d Probe P2 reading error delay (P2C=0-5V)
A11 P3C Probe P3 configuration
A12 P3F Probe P3 calibration
A13 P4C Probe P4 configuration
C6.1.10/0118-0318/E
Description
Not used (0-NU)
Suction pressure (0-5V)(1-SUP)
0-5V: -1.5 bar to P1E; -21 PSI to P1E
0-5V: P1i to 99.9 bar; P1i to 999 PSI
0-5V: -12.0 to 12.0 bar; -12.0 to12.0 PSI
0 to 255 min
Not used (0-NU)
Mid coil temperature (NTC10K)(1-MCT)
Mid coil pressure (0-5V)(2-MCP)
0-5V: -1.5 bar to P2E; -21 PSI to P2E
NTC10K: -40°C to P2E
0-5V: P2i to 99.9 bar; P2i to 999 PSI
NTC10K: P2i to 110°C
0-5V: -12.0 to 12.0 bar; -12.0 to 12.0 PSI
NTC10K: -12°C to 12°C
0 to 255 min
Not used (0-NU)
Discharge line temperature (1-DLT)
-12°C to 12°C
Not used (0-NU)
Ambient temp (NTC10K)(1-AMT)
Thermostat temp (NTC10K)(2-TMT)
Vapour inlet temp (NTC10K)(3-UIT)
Vapour outlet temp (NTC10K)(4-UOT)
Evaporator temp (NTC10K)(5-EPT)
Liquid temp (NTC10K)(6-LLT)
Suction line temp (7-SLT)
Coil temp (8-COT)
Range Factory setting
Suction pressure (0-
5V)
0
15
0
5
Mid-coil pressure (0-
5V)
0
35
0
0
Discharge line
temperature
0
Not used
ZXDI
L2
L2
L2
L2
L2
L2
L2
L2
L2
L2
L2
L2
L2
37