Table of Contents
Advertisement
6.1. Button Descriptions and Key Combinations
(SET) Select a parameter or confirm an
operation when in programming mode.
(RESTART) Hold for 5 seconds to reset
any lockouts if the current state of the
controller allows for reset. Allows a
manual restart and a "dead band reset".
(UP) View current measured values (Fast
Access Menu); in programming mode or
any menu to browse the parameter codes
or increase the displayed value.
(DOWN) in programming mode or any
menu to browse the parameter codes or
decrease the displayed value.
(SERVICE) To enter the service and
alarm menu.
Hold for 3 seconds to start a manual
defrost
Press and hold for about 3 sec to lock
+
(Pon) or unlock (PoF) the keyboard.
Press together to exit from programming
+
mode or from menu; on submenus to
return to previous level.
Press together for 3 sec to access to first
+
level of programming mode.
6.2. Changing a Parameter Value
To change a parameter value:
1. Hold down
the 'F' LED starts blinking to enter the module's
programming menu.
2. Use
or
to select the rtC or PAr menu
3. Press
to enter the menu.
4. Use
or
to select the required parameter.
5. Press the
key to display its value.
6. Use
or
to change its value.
7. Press
to store the new value.
TO EXIT: Press
without pressing a key.
NOTE: The set value is stored even when the procedure
is exited by waiting for the time-out to expire.
NOTE: If a menu does not have any parameters
available, noP will be displayed
© 2016 Emerson Climate Technologies, Inc.
keys for 3 seconds or until
or wait 60 seconds
6.3. Entering the Advanced Options Menu
1. Hold down
until the F LED starts blinking to enter the module's
programming menu.
2. Use
or
3. Press
to enter the PAr menu
4. Use
or
5. Press
to select PAS
6. The blinking PAS label will be showed for a few
seconds
7. Will be showed 0 - - with blinking 0: insert the
password [321] using the keys UP and DOWN and
confirming with SET key.
6.4. Moving Parameters Between the Programming
Menu and the Advanced Options Menu
While in the advanced options menu, certain parameters
will have a (.period) in between the 2nd and 3rd
character, for example Ci.n. These parameters are
in the Programming Menu as well as the Advanced
Options Menu.
To add or remove a parameter from the programming
menu, press the
the parameter name is on the display in the advanced
options menu. The (.period) between the 2nd and 3rd
parameter will either be added or removed.
TO EXIT: Press
without pressing the keys.
6.5. Locking the Keypad
1. Press the
2. The POF message will be displayed and the
keyboard will be locked. The Fast Access Menu
will remain accessible whil the keyboard is locked.
3. If a key is pressed more than 3 seconds the POF
message will be displayed.
6.6. Unlocking the Keypad
Press the
Pon message is displayed.
8
AE5-1412 R1
keys for 3 seconds or
to select the PAr menu
to select the PAS parameter
keys together while
or wait 60 seconds
keys for 3 seconds.
keys for 3 seconds until the
Hide quick links:
Advertisement
Table of Contents
