Control Panel & Menu Card Replacement - Henny Penny Evolution Elite EEG-16 Series Technical Manual

Using a 3/8" wrench, remove the nuts.
5 5 ) )
Remove the clamp bars.
6 6 ) )
Slide the high limit control off of mounting studs.
7 7 ) )
Install the new control in reverse order.
8 8 ) )
6 6 . . 6 6 M M a a i i n n P P o o w w e e r r S S w w i i t t c c h h
Lower the control board (see
1 1 ) )
page
Press on the switch from the inside of the fryer to release from the metal shroud.
2 2 ) )
Mark and disconnect the wires from the switch.
3 3 ) )
Connect the wires onto the new switch on the correct terminals.
4 4 ) )
Press back into factory location.
5 5 ) )
38
6.4 Control Panel & Menu Card Replacement ,
36).