Table of Contents
Advertisement
8
Inserting/Removing the
Module
Please ensure that all necessary electrostatic precautions are taken when
inserting or removing a module from the system. In addition, all power must be
removed from the system during this process.
The compute module is screwed down to the carrier board to ensure that the module
does not move during shipping. If for, any reason, the compute module needs to be
removed from the carrier, the following guidelines need to be followed:
8.1
Removal
1. Ensure that all necessary ESD steps have been taken.
2. Ensure the system is disconnected from wall power.
3. Remove the 2 screws holding the module in place.
4. Unlatch the module from the DIMM connector by simultaneously pushing on
the white clips on the DIMM connector.
8.2
Insertion
Figure 22 and Figure 23 show the required finger positions when inserting a module.
The module is inserted fully when the clips on the DIMM connector close. It is
recommend the spaces be inserted and the module secured to the carrier.
44
Inserting/Removing the Module
324421/ User Guide
Advertisement
Table of Contents
