How To Show/Hide Land Mass Emphasis - Furuno FAR-2218 Operator's Manual

[LIGHT BEACON]
set to [OFF].
5.11.5

How to show/hide land mass emphasis

[LAND MASS EPHASIS] sets whether to highlight the outer edge of land masses on
the display.
1. Open the menu.
2. Select [2 MARKS•CHART].
3. Select [0 NEXT].
4. Select [4 EMPHASIZE LAND MASS].
5. Select [OFF] to disable the emphasis. There are three levels of emphasis avail-
able; a higher setting gives a thicker emphasis line around the land mass.
6. Close the menu.
5.11.6 How to check your charts/symbol versions
You can check the version of your charts and symbols from the [CHART ADMINIS-
TRATION] menu.
1. Open the menu.
2. Select [9 INITIAL SETTINGS].
3. Select [8 UPDATE CHART]. The confirmation message "OTHER FUNCTIONS
WILL STOP DURING THE CHART UPDATE. ARE YOU SURE?" appears.
4. Select [RUN] to access the [CHART ADMINISTRATION] menu.
Instructions for these menu
items are contained in the
Installation Manual IME-36520
5. Select [6 BASECHARTS • SYMBOLS VERSION]. The version information for
your charts and symbols appears.
6. Right-click to go back to the [CHART ADMINISTRATION] menu.
7. Select [7 CLOSE]. The confirmation message [CLOSE CHART ADMINISTRA-
TION AND RESTART THE SYSTEM?] appears.
8. Select [RUN]. The system restarts.
[LIGHT SECTOR] set to [ON].
Light sector and range lines are dis-
played (range lines are long).
5. VIDEO PLOTTER OPERATION
[LIGHT SECTOR] set to [OFF].
Light sector is not displayed.
5-29