Furuno FAR-2218 Operator's Manual page 259

ALR ALF
Alert ID Alert ID
- 52602,2
Remedy: Press the ALARM ACK key. The indication is automatically removed when the signal is
restored or a different sensor is selected.
- 52602,3
Remedy: Press the ALARM ACK key. The indication is automatically removed when the signal is
restored or a different sensor is selected.
740 52740,1
Remedy: Press the ALARM ACK key. Restore the external radar to normal operating condition.
750 52740,2
Remedy: Press the ALARM ACK key. Check connection and power to the external radar.
760 52740,3
Remedy: Press the ALARM ACK key. Check transmission status of the external radar.
760 52740,4
Remedy: Press the ALARM ACK key. Check heading data input status for the external radar.
790 52790,1
Remedy: Press the ALARM ACK key. No other action required.
791 52791,1
Remedy: Press the ALARM ACK key. Check course and adjust as necessary.
950 52950,1
Remedy: Press the ALARM ACK key. Check connection to BAM. Check power to BAM.
- 52001,1
Remedy: Press the ALARM ACK key. Have a qualified technician check the fan.
APPENDIX 3 ALERT CODES, MESSAGES & MEANINGS
Alert title
SOURCE CHANGE
SOURCE CHANGE
EXT RADAR ERROR Warning
EXT RADAR ERROR Warning
EXT RADAR ER-
9
ROR*
EXT RADAR ER-
9
ROR*
ARRIVAL
XTD LIMIT
3
BAM COM ERROR*
HW STATUS NO-
TICE
Priority &
Category
Caution Message: "SPD SOURCE CHG"
Cat: B Meaning: Speed sensor input lost, au-
tomatically changed sensors.
Caution Message: "HDG SOURCE CHG"
Cat: B Meaning: Heading sensor input lost,
automatically changed sensors.
Message: "EXT RADAR NO SIGNAL"
Cat: B Meaning: Selected radar has an error.
(Only displayed when Interswitch is ac-
tive.)
Message: "EXT RADAR COM ER-
Cat: B ROR"
Meaning: Communication with exter-
nal radar interrupted or lost. (Only dis-
played when Interswitch is active.)
Warning Message: "EXT RADAR STBY"
Cat: B Meaning: External radar entered
standby mode.
Warning Message: "EXT RADAR NO SEN-
Cat: B SOR"
Meaning: No heading data was re-
ceived from the external radar for more
than five seconds.
Warning Message: "ARRIVED AT WPT"
Cat: B Meaning: Ship has entered the desti-
nation arrival alert zone.
Note: This alert appears on B/W-type
radars only.
Warning Message: "XTD LIMIT EXCEEDED"
Cat: B Meaning: Cross-track error, ship is off-
course.
Note: This alert appears on B/W-type
radars only.
Caution Message: "BAM COM ERROR"
Cat: B Meaning: Communication with the
Bridge Alert Management System in-
terrupted.
Caution Message: "RPU:FAN1 SPD ERROR"
Cat: B Meaning: FAN1 in the processor unit
has low RPM.
Alert description
AP-15