Table of Contents
Advertisement
Assembly
5.2 Preparations for installation
Damage to mounted parts and components as a result of high temperatures
The motor components get very hot during operation. High temperatures can damage parts
mounted by customers, such as cables manufactured out of materials that are not heat
resistant.
● Temperature-sensitive parts must not come into contact with or be attached to components
● Only use heat-resistant mounting parts. The connecting cables and cable entries must be
Loss of conformity with European directives
In the delivery state, the machine corresponds to the requirements of the European directives.
Unauthorized changes or modifications to the machine lead to the loss of conformity with
European Directives and the loss of the associated warranty.
Explosion hazard when making modifications to the machine
Substantial modifications to the machine are not permitted – or may only be performed by the
manufacturer. Otherwise an explosion can occur in an explosive atmosphere. This can result
in death, serious injury or material damage.
● If necessary, please contact the service center.
See also
Service and Support (Page 167)
5.2
Preparations for installation
5.2.1
Requirements for installation
The following requirements must be satisfied prior to starting installation work:
● Staff have access to the operating and installation instructions.
● The machine is unpacked and ready for mounting at the installation location.
● Measure the insulation resistance of the winding before starting any installation work. If the
52
mounted on the machine.
suitable for the particular application.
insulation resistance lies below the specified value, take appropriate remedial measures.
These remedial measures may necessitate the machine being removed again and
transported.
SIMOTICS FD 1MM1
Operating Instructions 02/2019
Advertisement
Table of Contents
