Messages - Siemens CP 1243-8 IRC Operating Instructions Manual

Configuration and operation
4.7 Configuration in STEP 7 Basic
Note
Evaluation of the value even when the option is disabled
If you enable one or both options and configure a value and then disable the option later, the
grayed out value is nevertheless evaluated.
To disable the two options, delete the previously configured values limit values from the input
boxes and then disable the relevant option.
Recommendation for quickly fluctuating analog values:
If the analog value fluctuates quickly, it may be useful to smooth the analog value first if limit
values are configured.
4.7.17

Messages

Configuring SMS messages
If important events occur, the CP can send SMS messages to a mobile phone.
You configure the SMS message in STEP 7 in the data point and message configuration.
You can find this using the project tree:
Project > directory of the relevant station > Local modules > CP
For the view in STEP 7, refer to the section Configuring data points and messages
(Page 68).
You will find the character set supported for the text of the SMS message in the section
Character set SMS (Page 88).
For the configuration of the SMSC, refer to the section "Serial Interface" parameter group
(Page 62).
Configuring e-mails
If important events occur, the CP can send e-mails. The recipient can be a PC with an
Internet connection or an S7-1200.
You configure the e-mails in STEP 7 in the data point and message configuration. You can
find this using the project tree:
Project > directory of the relevant station > Local modules > CP
For the view in STEP 7, refer to the section Configuring data points and messages
(Page 68).
84
Operating Instructions, 06/2015, C79000-G8976-C385-01
CP 1243-8 IRC