Connecting Cables; Connecting Cables For Connecting The Cp To Ethernet; C.4 Connecting Cables - Siemens CP 1243-8 IRC Operating Instructions Manual

Accessories

C.4 Connecting cables

Short name
ANT794-4MR
You will find detailed information in the documentation of the device. You will find this on the
Internet on the pages of Siemens Industry Online Support under the following entry ID:
23119005 (http://support.automation.siemens.com/WW/view/en/23119005)
C.4

Connecting cables

C.4.1

Connecting cables for connecting the CP to Ethernet

Connecting cables for connecting to Ethernet
For the Ethernet attachment of the TIM 4RIE DNP3, you can use a standard Ethernet
connecting cable (for example IE TP Cord) from the SIMATIC NET product range (catalog
IK PI).
The cable must be suitable for the 10Base-TX or 100Base-TX Ethernet specification.
If the CP is connected to a switch or router, it is advisable to use fully shielded straight-
through patch cables with RJ-45 connectors at both ends and 1:1 pin assignment. The cable
must be suitable for the 10Base-TX or 100Base-TX specification.
You can also use a crossover patch cable with RJ-45 connectors at both ends and the
following pin assignment:
Figure C-7
130
Order no.
6NH9 860-1AA00
Pinout of a crossover Ethernet RJ-45 cable
Explanation
Omnidirectional antenna for LTE networks (4G),
GSM networks (2G) and UMTS networks (3G);
weatherproof for indoor and outdoor areas; 5 m
connecting cable connected permanently to the
antenna, SMA connector, including installation
bracket, screws, wall plugs.
Operating Instructions, 06/2015, C79000-G8976-C385-01
CP 1243-8 IRC